Manual

ManualsBrandsGraymills ManualsPumpsDual Head Peristaltic OMI

Addendum to Operating Manual 795-09456-B 06-13

for

Dual Head PERISTALTIC INK PUMPS

SAFETY-Do Not operate pump without both Pump Heads installed on the motor housing. Both Pump Heads

must be properly and securely installed on the pump for safe operation.

CAUTION-

 Pump Heads must be fully inserted into motor’s hollow shaft and spring pin must be fully engaged into

mated aluminum adapter.

 DO NOT depress Release Lever while pump is in operation. Stop pump before pushing release lever.

 DO NOT attempt to remove, rotate or make any adjustments to Pump Heads while pump is in

operation.

WARNING-

 Disconnect power supply to the Remote Control unit before making any connections, adjustments or

performing service work

 The Dual Head Pump has two head sizes: small (PQS) and large (PQL). The pump motor will accept

either pump head size, but the remote control unit is factory set for one specific model. Do not drive

small heads with a large control unit, or drive a large head with a small control unit.

 DO NOT disconnect motor or power cord while pump is in operation.

 DO NOT plug motor cord into any other device except the model specific Remote Control unit.

 DO NOT use the Remote Control unit to power or drive any other device.

OPERATING VOLTAGES

 PPL-DV-DH, PPS-DV-DH DC Motor 115/230VAC 50/60 Hz 1 Phase. Voltage selection is done

automatically. No settings or switches to change.

NOTE: This “addendum” to the Operating and Maintenance Instruction

(OMI) #795-09456 is intended for use with Dual Head Peristaltic Ink Pumps.

All users of the Dual Head must first review OMI #795-09456 for complete instructions

regarding general peristaltic pump safety, operation and installation. All instructions contained

here apply to unique characteristics of the Dual Head Peristaltic Ink Pump only

Figure A (Upper Left)

Dual Head Pump and

Remote Control Unit

Figure B (Upper Right)

Removable Head and

Release Lever

Figure C (Lower Left)

Remote Control Unit-

Motor Cord and Power

Cord connection

Figure D (Lower Right)

Remote Control Unit-

Pump Speed and

Direction Control

Figure A

Figure B

Figure C

Figure D

Summary of content (3 pages)

PAGE 1
Addendum to Operating Manual for Dual Head PERISTALTIC INK PUMPS 795-09456-B 06-13 NOTE: This “addendum” to the Operating and Maintenance Instruction (OMI) #795-09456 is intended for use with Dual Head Peristaltic Ink Pumps. All users of the Dual Head must first review OMI #795-09456 for complete instructions regarding general peristaltic pump safety, operation and installation.
PAGE 2
ABOUT Dual Head PERISTALTIC PUMPS The Dual Head Peristaltic Ink pump can be used to supply and draw back ink/fluid to one print deck, supply the same ink/fluid to two different decks, or supply different ink/fluids to two different decks. The Dual Head Peristaltic pump includes a hollow shaft pump motor (with female adapters and cord), two pump heads (large or small) with male adapters, remote control unit, mounting frame and power cord.
PAGE 3
SERVICING PUMP PUMP HEAD ADAPTER REPLACEMENT To attach new adapter to pump head in case of damage to adapter For Dual Head Peristaltics, the following:  Stop pump and disconnect power supply.  Press Release Lever and remove Pump Head Assembly from motor.  Unscrew and pivot three Quick Release screws and remove outside half of Pump Head.  Unscrew four (4) cap screws to remove old Male Adapter from inside Pump Head.