User guide

ManualsBrandsGraymills ManualsWater equipmentHandi-Kleen PH822-A OMI

795-92072

05/08

Graymills

Model PH822-A Heated Handi-Kleen

Recirculating Parts Cleaner

Operations and Maintenance Instructions

Be sure anyone operating this unit reads and understands all warnings and instructions. Keep this

manual available for reference/training.

SAFETY WARNINGS

You will find various types of safety information on the following pages and on the labels attached to Graymills equipment. The following

Safety Statements explain their meaning:

This is the safety alert symbol. It is used to alert you to potential personal injury

hazards. Obey all safety messages that follow this symbol to avoid personal injury or

death.

DANGER indicates a hazardous situation which, if not avoided, will result in death or

serious injury.

WARNING indicates a hazardous situation which, if not avoided, could result in death

or serious injury.

CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if

not avoided, could result in minor or moderate injury.

CAUTION, without the safety alert symbol, is used to address practices not related to

personal injury.

READ BEFORE OPERATING

• Never use a flammable or combustible fluid in this

unit. Use only nonflammable, non-combustible,

water-based, low foaming cleaning compounds in this

machine. For best results, Graymills’ recommends

using Aquatene 330, Super Aquatene 360, or

Aquatene 571.

• Do NOT contaminate cleaning fluid with any

flammable or combustible material such as gasoline,

alcohol, mineral spirits, etc. Drain parts to be cleaned

of any flammable material or combustible material

before placing inside cleaning tank. Even small

quantities can create a dangerous fire hazard.

• Never work with equipment you feel may be unsafe.

Contact your supervisor immediately if you feel a

piece of equipment is in an unsafe condition.

• Cleaning solutions may be irritating to skin and eyes.

Always wear gloves, apron and safety glasses when

using. If splashed in eyes, flush thoroughly with water

and follow directions on cleaning solution MSDS.

• Install machine in a well ventilated area to avoid possible

buildup of cleaning solution fumes.

Summary of content (6 pages)

PAGE 1
795-92072 05/08 Graymills Model PH822-A Heated Handi-Kleen® Recirculating Parts Cleaner Operations and Maintenance Instructions Be sure anyone operating this unit reads and understands all warnings and instructions. Keep this manual available for reference/training. SAFETY WARNINGS You will find various types of safety information on the following pages and on the labels attached to Graymills equipment. The following Safety Statements explain their meaning: This is the safety alert symbol.
PAGE 2
795-92072 05/08 • • • • POWER SUPPLY, WIRING AND GROUNDING Cleaning fluids should have a pH under 12.5. This is a heated system. Always use caution when first putting hand into cleaning solution. Higher temperatures can cause burns to skin and will damage pump. This unit's thermostat has a maximum temperature of 120ºF. Do NOT attempt to exceed thermostat setting.
PAGE 3
795-92072 05/08 MACHINE OPERATION 1. RECOMMENDED MAINTENANCE Inspect pump, electrical cord and plug. Be sure electrical cord is unplugged and cleaning solution and heater coil is cool before performing any maintenance. 1. To maximize cleaning efficiency, fluid should be changed regularly. Heavy, constant use may warrant daily fluid changes. 2. Inspect heater coil on a monthly basis. To inspect, remove baffle screen. Remove any deposits or buildup with a soft wire brush.
PAGE 4
795-92072 05/08 TROUBLESHOOTING Problem No Machine Function Heat Not Working Red “RESET” Light ON Little or No Fluid Flow Probable Cause Suggested Remedy Machine unplugged Plug machine into appropriate wall socket GFCI tripped Press RESET button on GFCI No power at outlet Consult plant electrician Thermostat tripped Press red thermostat reset button Heater malfunction Contact Graymills for more information 1-888-472-9645 Heater coil dirty Clean heater coil (see Recommended Maintenance) Ma
PAGE 5
795-92072 05/08 PH822-A DRAWING AND PARTS LIST REF DESCRIPTION PART NO.
PAGE 6
795-92072 05/08 ELECTRICAL SCHEMATIC WARRANTY INFORMATION G r a y m i l l s Corpora t i o n warrants that the equipment manufactured and delivered, when properly installed and maintained, shall be free from defects in workmanship and will function as quoted in the published specification. G r a y m i l l s does not warrant process performance, nor assume any liability for equipment selection, adaptation, or installation.