M

Addendum to Operating Manual 795-09456-C 12-07

for

“Quick Change” PERISTALTIC INK PUMPS and Retrofit Kits to

Convert SPLASH RESISTANT PUMPS to “Quick Change”

SINGLE HEAD PERISTALTIC PUMPS

SAFETY-Do Not operate pump without Pump Head installed on the motor housing. Pump Head must be

properly and securely installed on the pump for safe operation.

CAUTION-

• Pump Head must be fully inserted into the adapter and Retractable Pin must be fully engaged for

pump to operate properly.

• DO NOT pull Retractable Pin while pump is in operation. Stop pump before pulling pin.

• DO NOT attempt to remove, rotate or make any adjustments to Pump Head while pump is in

operation.

WARNING-

• Disconnect power supply to the pump before making any connections, adjustments or performing

service work

• The “Quick Change” Pump has two head sizes: PPS and PPL. The Retrofit Kit must match your pump

head size: Kit C-39598 converts the PPS (Small) to the PQS Quick Change head; and the C-39601

converts the PPL (Large) to the PQL Quick Change head.

The Retrofit Kits to convert Splash Resistant Pumps to “Quick Change” Heads are:

 Graymills Part Number C-39598 to Convert Small Pump Heads (PPS) to the “Quick

Change” (PQS) Head;

 Graymills Part Number C-39601 to Convert Large Pump Heads (PPL) to the “Quick

Change” (PQL) Head.

NOTE: All users of the “Quick Change” Single Head must first review OMI #795-09456 for

complete instructions regarding general peristaltic pump safety, operation and installation. All

instructions contained here apply to unique characteristics of the Single Head Peristaltic Ink

Pump only.

Splash Resistant Peristaltic Pump

“Quick Change” Peristaltic Pump with

Removable Head

PAGE 1
Addendum to Operating Manual 795-09456-C 12-07 for “Quick Change” PERISTALTIC INK PUMPS and Retrofit Kits to Convert SPLASH RESISTANT PUMPS to “Quick Change” SINGLE HEAD PERISTALTIC PUMPS The Retrofit Kits to convert Splash Resistant Pumps to “Quick Change” Heads are:  Graymills Part Number C-39598 to Convert Small Pump Heads (PPS) to the “Quick Change” (PQS) Head;  Graymills Part Number C-39601 to Convert Large Pump Heads (PPL) to the “Quick Change” (PQL) Head.
PAGE 2
ABOUT the Retrofit Kit for “Quick Change” Single Head PERISTALTIC PUMPS This instruction is intended to be used with two types of Peristaltic Pump-the pump configured as a “Quick Change” pump as manufactured by Graymills; and the Splash Resistant pump converted to the “Quick Change” head in the field by use of a Retrofit Kit. Components of Retrofit Kit for “Quick Change” Peristaltic Pumps 8 1 2 3 4 5 6 1. 2. 3. 4. 5. 6. 7. 8.
PAGE 3
PUMP HEAD REMOVAL/INSTALLATION for “Quick Change” pump Installing or removing a complete Pump Head, Male Adapter and Hose assembly. Once the retrofit kit is installed on the pump, installation/removal of pump head is the same for both the retrofit and the factory-built version: • Stop pump and disconnect power supply. • Pull Retractable Pin and remove current Pump Head Assembly from motor. The head can be removed with hose in head, thus speeding changeovers.