Installation Guide

Trim
thickness
Rip-saw
this board
12
OUTSIDE/INSIDE CORNER

Recommend using Kleer Konceal Cornerboards or equivalent. Refer to manufacturers
installation guide for additional information.

All corner sheathing must be properly ashed prior to installing cornerboards (Fig 12).

Outside and Inside corners must be installed prior to installing the Grayne Siding Panel.

Inside corners you will need to rip-saw along the length of one of the trim boards
the board thickness, to achieve an even reveal surface on each side (Fig 13).
Flashing should extend 4"
beyond end of Corner Trim
Caulk may be applied
along this location if
prefered
Grayne Siding Panel
Kleer Konceal
Corner Board
OUTSIDE CORNER
INSIDE CORNER
Both reveal surfaces
must equal the
same dimension
Kleer Konceal
Corner Board
FIGURE 12
FIGURE 13
Flashing should extend 4"
beyond end of Corner Trim