Old Fashioned Gumball Machine MODEL: 6260 Gumball Machine with Stand 6265 15 Inch Gumball Machine 6270 11 Inch Gumball Machine ASSEMBLY & INSTRUCTIONS Copyright 2011 DTX International
Old Fashioned Gumball Machine ASSEMBLY AND USE Enjoying Your Old Fashioned Gumball Machine Your stand-alone gumball machine comes fully assembled. If you purchased the gumball machine with stand, please visit page 4 of this manual for instructions on stand assembly.
Old Fashioned Gumball Machine ASSEMBLY AND USE Enjoying Your Old Fashioned Gumball Machine...Continued CONTROLLING CANDY FLOW: You may wish to alter the rate at which your product is dispensed. To do so: 1. Remove the cap lock, cap, nut, ring and gasket and the brush-off plate (6). 2. Next, adjust the dispensing wheel. If your wheel is not able to turn, your model may have the wheel held in place with set screws. Simply loosen them enough for the wheel to turn, adjust and then re-tighten. 3. Reassemble.
Old Fashioned Gumball Machine ASSEMBLY AND USE Gumball Machine Stand Assembly If you have purchased model 6260 Gumball Machine with Stand you will need to do some very minor assembly to put the stand together. To assemble your stand: Top Column 1. First screw in the top column into the bottom column. 2. Next, attach each leg to the base with a nut and bolt provided as shown. Use a screwdriver, but do not overtighten. 3. Lastly, screw the connected columns into the base.