Use and Care Manual

OPERATING PROCEDURES

Cotton Candy Machine Controls & Operation

1. Turn the Power Switch to ON by pushing down

on the red switch (Figure M). Observe the stability

of your machine. Check for excessive vibration

and if you notice this, turn the Power Switch to

OFF, unplug the machine and make sure that

your working surface is level. Check to see that

the floss head is sitting levelly and evenly.

2. To bring the machine up to temperature, turn the

Heating Controller Switch (Figure N) to ON.

Allow to heat up for 2-4 minutes; the floss head

will heat to a temperature of around 445 degrees

F, so take care to keep body parts and flammable

materials away when the machine is in operation.

Subsequent batches will not require a preheating

period.

3. After machine is hot, add 1 scoop (with the sugar

ladle provided) of cotton candy floss mixture into

the spinner head (Figure P). USE CAUTION!

FLOSS HEAD IS SPINNING AT ULTRA-HIGH SPEEDS. TAKE CARE

NOT TO CONTACT THE SPINNING HEAD WITH YOUR HAND OR

THE SCOOP! DO NOT OVERFILL. OVERFILLING CAN LEAD TO

EXCESSIVE SMOKING.

4. Within 5-45 seconds, cotton candy floss will appear (Figure Q, also, see

page 10 for cone-building instructions). Make sure to spin the floss head

until all sugar is gone.

VERY IMPORTANT! FAILURE TO BURN OFF AND SPIN OFF EXCESS

SUGAR COULD LEAD TO SMOKING AND/OR BURNED SUGAR

DURING NEXT RUN CYCLE.

Repeat steps 3-4 to continue spinning floss; once the machine is

warmed up, no preheating is needed.

5. To clean the floss head, TURN MACHINE OFF, UNPLUG AND ALLOW

TO COOL COMPLETELY, THEN WIPE WITH A CLEAN MOISTENED

WARM SOFT CLOTH. CLEAN MACHINE AFTER EVERY USE.