Operator Manual Owner manual

23
Section 3 Adjustments
4/12/05
705 and 1005 End-Wheel No-Till Drill 150-213M
Great Plains Mfg., Inc.
KNOB SETTING NUMBER
Row 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
Spacing Pounds Per Acre
7" 0 11 21 40 57 75 93 111 128 144 163 181 196 217 232 245 252 258 260
7 1/2" 0 10 19 37 51 69 85 100 116 131 148 164 178 198 211 223 230 234 236
8" 0 10 19 37 51 69 85 100 116 131 148 164 178 198 211 223 230 234 236
10" 0 8 16 29 41 55 68 80 93 105 119 132 143 158 169 178 184 187 189
Fertilizer Rate
On fertilizer drills, the fertilizer-application rate is directly
related to ground speed. To adjust the application rate,
turn adjustment knob on back of fertilizer tray. See Figure
3-1. This controls the size of the fertilizer outlet. For fertil-
izer rates, refer to the chart below.
The application rates for dry, granular fertilizer depend on
many factors, including fertilizer type, fertilizer density, rel-
ative humidity and moisture content of the material.
Fertilizer Rate Chart
Density Conversion Chart
The fertilizer rate chart is based on fertilizer with a density
of 65 pounds per cubic foot. If you are applying fertilizer of
a different density, use the following table to convert your
application rate.
Density, pounds per ft.
3
45.00 50.00 55.00 60.00 65.00 70.00 75.00 80.00
Conversion Factor 1.45 1.30 1.20 1.10 1.00 0.93 0.87 0.81
Small Seeds Attachment
To set and calibrate the seeding rate on the optional small-
seeds attachment, follow these steps.
1. Set seed-rate handle on small-seeds attachment as
indicated by the Small Seeds Rate Chart, page 24.
2. Calibrate small-seeds attachment to your material by
following steps under Checking the Seeding Rate,
page 15.
Example: Your fertilizer has a density of 75 pounds per
cubic foot, and you want to apply 100 pounds per acre.
Multiply desired application rate by the conversion fac-
tor.
100 x 0.87 = 87
Adjust drill to setting closest to 87 pounds per acre.
17454
Figure 3-1
Fertilizer Adjustment Knob