CHARTRUSE Predelivery Instructions 1300 13-Foot, End-Wheel Drill Manufacturing, Inc. www.greatplainsmfg.com ! Read this manual entirely. When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it! 16677 Cover illustration may show optional equipment not supplied with standard unit.
Great Plains Mfg., Inc. Table of Contents Table of Contents Important Safety Information . . . . . . . . . . . . . . . . . Safety Notations. . . . . . . . . . . . . . . . . . . . . . . . . . Safety Rules. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of Unit . . . . . . . . . . . . . . . . . . . . . . . . Using This Manual . . . . . . . . . . . . . . . . . . . . . . . . Assembly and Setup Assistance . . . . .
Great Plains Mfg., Inc. Important Safety Information Important Safety Information For your safety, thoroughly read “Important Safety Information” and “Operating Instructions” in the operator’s manual before proceeding. Safety Notations ! The SAFETY ALERT SYMBOL indicates that there is a potential hazard to personal safety involved and extra safety precautions must be taken. When you see this symbol, be alert and carefully read the message that follows it.
Great Plains Mfg., Inc. Introduction Introduction Great Plains Manufacturing wants you to be satisfied with any new machine delivered by the Great Plains Trucking network. To ease the assembly task and produce a properly working machine, read this entire manual before assembling or setting up new equipment. Description of Unit The 1300 is a towed seeding implement. Working width is 13 feet. Double disks open a seed furrow. Press wheels follow the disks to control seeding depth and close the furrow.
Great Plains Mfg., Inc. Section 1 Assembly Section 1 Assembly The following headings are step-by-step instructions for assembling the drill. Begin with Tools Required and PreAssembly Checklist to make sure you have all necessary parts and equipment. Then proceed with Drill Assembly. Follow each step to make the job as quick and safe as possible and produce a properly working machine. Drill Assembly The drill is shipped via flat bed truck. It is the dealer’s responsibility to unload the new machine.
Great Plains Mfg., Inc. Section 1 Assembly Refer to Figure 1-2. 5. Install the left-hand pull bar (1). Slide the pull bar into the brace (2) on the frame. Install but do not tighten the 1/2-by-5-inch bolt, lock washer and nut (3). Install but do not tighten the 1/2-by-3-inch bolt, lock washer and nut (4). Repeat for right-hand pull bar. 6. Clamp pull bars around tongue by installing the 1/2-by 1 3/4-inch bolts, flat washers, lock washers, and nuts (5). Do not tighten bolts. 7.
Great Plains Mfg., Inc. Appendix Appendix Torque Values Chart for Common Bolt Sizes Bolt Head Identification Bolt Size (Inches) in-tpi1 Grade 2 Grade 5 Bolt Head Identification Bolt Size (Metric) Grade 8 N · m2 ft-lb3 N·m ft-lb N·m ft-lb mm x pitch 4 1/4" - 20 7.4 5.6 11 8 16 12 M 5 X 0.8 5.8 8.8 Class 5.8 10.9 Class 8.8 Class 10.9 N·m ft-lb N·m ft-lb N·m ft-lb 4 3 6 5 9 7 1/4" - 28 8.
Great Plains Manufacturing, Inc. Corporate Office: PO.