Manual

OPERATOR’S MANUAL
Auto Section Control System
11001-1561B-201207
26 / AUTO SECTION CONTROL SETUP
11. Measure the distance from the center of the receiver to the distance
from the center front axle. Enter the distance into the Axle to Receiver
input box.
12. Measure the distance from the center of the front axle to the center of
the tractor pivot point. Enter the distance into the Front to Pivot input
box.
13. Measure the distance from the center of the rear axle to the center of
the tractor pivot point. Enter the distance into the Pivot to Rear input
box.
14. Measure the distance from the rear axle center to the implement hitch
pivot point for pull-type implements . Enter the distance into the Axle to
Hitch input box.
Figure 26
Articulated GPS Setup Screen
GPS CALIBRATION
A GPS calibration test should be performed to determine the GPS lag time
that occurs between the Auto Section Control system and the GPS receiver.
IMPORTANT: The most accurate calibration test is to drive over a fixed
reference line that can visually be seen from the cab
versus driving past an object.
1. Place a fixed reference line in the field to drive over, such as a rope or
painted line.
2. Drive until the front tires are sitting on the reference line.
3. At the System Setup screen, press the GPS Setup button.
4. At the GPS Setup screen, press the Calibration button.
5. With ground speed at 0, press the Set Reference button.
IMPORTANT: Ground speed must be 0 for the Set Reference button to
appear.
RS232
0.5
96
84