Manual

OPERATOR’S MANUAL
Auto Section Control System
11001-1561B-201207
SYSTEM OPERATION / 43
The system cannot differentiate between a marked and already planted
area. Therefore, when planting the marked headland, the section control
must be in manual. The field map planting area will appear in blue which is
the indication of overplanting. However, overplanting is not occurring since
the first pass was marked and no seeds were dropped.
If only the inner most headland is marked, this is the only headland that
requires the control to be in manual. All other headlands can be planted in
Auto mode.
Figure 42
Planting a Marked Headland
STORING HEADLANDS
The following steps should be performed to ensure that headlands are
saved:
1. At the Auto Section Main Work screen, press the Select Task button.
2. At the Select Task screen, press the Open Task button to return to the
Main Work screen.
3. No further action required.
LOST GPS SIGNAL
A NO GPS screen on the Auto Section Control terminal indicates a GPS
signal cannot be found, has been lost, or the signal quality is not at
acceptable levels.
Potential causes:
• GPS setup incorrect.
– Check GPS Setup screen for proper inputs
– Check GPS status at the Diagnostics screen
• GPS signal blocked.
– Move to a clear area
• GPS receiver failure.
– Check receiver connection
In the event of a lost GPS signal, switch Auto Section Control to Manual
mode to continue planting.
Planting Marked
Headlands
(Manual Mode)
Planted in rows
(Auto Mode)
Inner
Headland