Owner manual

206-013M
4/13/2009
6
Seed-Lok™ Mounting Instructions
for John Deere 7200 Planters
Consult page 12, Parts Section,
for all part (#) references:
1. Lower planter to ground.
2. Remove one gauge wheel (not shown in figures
below) by removing the bolt at the wheel’s pivot
point. Take note of spacers located on the spindle to
ensure the wheel is correctly remounted. If scrapers
are currently used, or to ease installation both
gauge wheels must be removed.
3. Lift the depth control handle to its highest position.
4. Insert the edge of the Seed-Lok™ Mount (#3) in the
bottom of the opener body, see Figure 2.
5. Turn the mount to a vertical position and slide
forward until the holes align with those of the opener
body.
6. Secure the Seed-Lok™ mount by screwing the bolts
(#1) with spacer (#2) through the opener body and
into the flanged nuts (#4) on the inside of the mount
(#3) see Figure 4.
7. Place the Seed-Lok™ assembly (#11) on the bot-
tom side of the Seed-Lok™ mount (#3) and insert
the 1 1/4" x 3/8" carriage bolts and flanged nuts
(#21), and (#20).
8. Follow the instructions in " Adjustments", on Page 9,
to initially set your Seed-Lok™ Wheels.
9. Reinstall gauge wheels.
!
CAUTION
Do not run infurrow fertilizers in front of the seed-lok™ due
to possible bearing problems.
Note: If scraper use is still desired place them be-
tween the washer and opener body before tighten-
ing bolts.
13262
Figure 1
Figure 3
Figure 2
Figure 4