Owner's manual

4/18/2006

204-085M

Maintenance and Lubrication

Yield-Pro® Single Unit Mount

Row Cleaner Installation

Single Arm

Refer to Figure 2

1. Assemble row cleaner to the row cleaner arm.

2. Insert the arm pivot bushings (5) in the upper

holes of the unit mount (3). Insert the bush-

ings from the inside and press until the shoul-

der of the bushing rests against the frame.

3. Insert the 1/2” x 1 3/4” carriage bolts (2) into

the row cleaner mount (1).

NOTE: Insert the bolts from the outside so the

nuts will be on the inside of the frame.

4. Thread on the 1/2” ﬂange nuts (6) and hard-

ened washer (7). Tighten ﬂange nuts.

NOTE: Single arm row cleaner mounts in lower

hole of unit mount.

Figure 2

Single Arm Assembly

22944

Maintenance

Proper servicing and adjustment is the key to the

long life of any farm implement. With careful and

systematic inspection, you can avoid costly mainte-

nance, time and repair.

After using your Yield-Pro® Row Cleaner for several

hours, check all bolts to be sure they are tight.

Storage

Clean the Yield-Pro® Row Cleaner as necessary.

For longer equipment life store inside if possible.

Maintenance and Lubrication