Manual

ManualsBrandsGreat Plains ManualsHardwarePress Wheel Mount Kit 25 Series

Part Lists Great Plains Manufacturing, Inc. 1

Press Wheel Mount Update Kit

25 and 25AP Series Implements

General Information

These instructions explain how to install a Press Wheel

Mount Update Kit. One kit updates one opener.

These instructions apply to an installation of:

Summary of content (6 pages)

PAGE 1
Part Lists Great Plains Manufacturing, Inc. 1 Press Wheel Mount Update Kit 25 and 25AP Series Implements When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it! General Information These instructions explain how to install a Press Wheel Mount Update Kit. One kit updates one opener.
PAGE 2
Great Plains Manufacturing, Inc. Front Page Part Lists Press Wheel Mount Update Pre-Assembly Preparation Tools Required • suitable tractor for raising implement • basic hand tools • dead blow hammer or press Crushing and Sharp Object Hazards: Be careful working near openers. Discs and other parts may be sharp. Work Location 1.
PAGE 3
Remove Old PW Mount Front Page Part Lists Great Plains Manufacturing, Inc. 3 Remove Old PW Mount Refer to Figure 3 With openers slightly off ground spring tension is released. 4. To detach press wheel assembly from opener body 2 remove two vertical bolts, washers, and nuts from underside of press wheel mount: 56 802-091C HHCS 1/2-13X1 1/2 GR5 57 802-258C HHCS 1/2-13X1 GR5 61 804-015C WASHER LOCK SPRING 1/2 PLT 55 405-032D 1X12 PW ADJUSTER Save hardware for reuse. 5.
PAGE 4
Great Plains Manufacturing, Inc. Front Page Part Lists Press Wheel Mount Update Install New PW Mount Refer to Figure 4 7. With press or dead blow hammer insert one bushing 22 in hole 3 on each side of the press wheel arm 1 . Install one pivot spacer 21 into each bushing. 22 890-598C BUSHING 3/4OD X 5/8ID X 1/2 21 890-524C 20 SER PW ARM PIVOT SPACER 8. Select one new press wheel mount 13 or 14 : Note: The press wheel assemblies can have either all long or all short mounts or a combination of the two.
PAGE 5
Appendix Front Page Part Lists Great Plains Manufacturing, Inc. 5 Appendix Part Lists New Parts The part call-out numbers in this list match all Figures in these installation instructions. Part descriptions match those in your updated Parts Manual. Quantities are units (“ea”).
PAGE 6
Front Page Part Lists Abbreviations 3PT A F GR5 HHCS OD PLT 3 Point Air-Pro Fluted Grade 5 Hex Head Cap Screw Outside Diameter Plated PW RHSNB SAE SER W/ X Press Wheel Round Head Shank Neck Bolt Society of Automotive Engineers Series With By Great Plains Manufacturing, Inc. Corporate Office P.O.