Manual

Great Plains Manufacturing, Inc. Update Lift Cylinders 11

08/06/2007 596-186M

Install Non-Rotate Assemblies

Refer to Figure 19 (showing left arm in cutaway)

The non-rotate assemblies are normally

installed as

mirror images of each other, but the component parts are

identical (symmetrical). Start with the left arm.

45. Select two new:

596-182S PIN 1 1/4 NON ROTATE ASY

and disassemble them. Set aside the pin (not

shown), one bolt and one nut each, and have at

hand the following:

(2) 308-041D TUBE 1 OD X 5/32 WL X 13/16

(1) 596-252D NON ROTATING PIN KEEPER

(1) 596-253D NON ROTATING PIN BASE

(2) 802-130C HHCS 1/2-13X2 1/2 GR5

(2) 803-019C NUT LOCK 1/2-13 PLT

46. Using the pin , determine which side of the lug

has greater clearance. Re-assemble the non-rotate

assembly for that orientation

47. Loosely re-assemble the non-rotate base and keeper

as shown. The cut corners of the base face toward

the arm lug and the bent-up ears brace against the

arm tube. The top lug of the keeper tilts toward

implement front.

48. Repeat step 45 and step 47 for the right side.

Install New Clevis: SN1063+

If your implement is serial number 1062 or lower, skip to

“Position Cylinder Rod End”.

Refer to Figure 28 on page 18

49. Select two new:

1M7022-ADI MW ROD CLEVIS 1.25PN 1.5-12THD

Loosen the collar bolts.

50. Install the new clevis assemblies on the transport

lift cylinder rod ends. Tighten the collar bolts.

51. Skip to “Position Cylinder Rod End” on page 13

1. Due to normal manufacturing tolerances, there may be more clearance on one side of the lug vs. the other. The pin

keeper may be installed to the inside or the outside of the lug, but the top of the keeper must tilt toward implement front

and the bent ears of the base must be against the arm tube.

Figure 19

Non-Rotate Keeper & Base

27047

Figure 20

Clevis Replacement

27040