Manual

12 Verti-Till Field Update Great Plains Manufacturing, Inc.

596-186M 08/06/2007

Install New Cylinder: SN1062-

If your implement is serial number 1063 or higher, it

already has the current cylinder and pin. Skip to “Install

New Clevis: SN1063+” on page 11.

Starting with the left side:

Refer to Figure 21

52. Select one each new:

810-584C CYL 4.25X8X2.0RD 1.25BX1R HOLE

160-401D CART LINK PIN 1 1/4 X 7 13/32

53. Select two saved:

EL 3/4MJIC 3/4MORB (elbows)

Screw the elbows into the base and rod end hydrau-

lic ports of the new cylinder. Orient the elbows as

noted at step 34 (or consult the other side of imple-

ment for reference). Tighten the jam nuts.

54. Mount the base end of the cylinder at the frame,

using the new pin , and in the same hydraulic port

orientation as used by the cylinder noted at step 34

(or consult the other side of implement for refer-

ence).

55. Select one each new:

802-849C HHCS 3/8-16X3 1/4 GR8

803-013C NUT LOCK 3/8-16 PLT

Secure the pin with the bolt and nut.

56. Loosely reconnect the FJIC ends of the base and

rod end hydraulic hoses to their respective elbows

on the new cylinder. These connect are left loose so

that the rod clevis can be easily positioned in later

step.

57. Repeat step 33 through step 56 for the right side.

58. The new cylinder includes new channel locks and

pins:

596-163H CYL LOCK CHANNEL 2 X 9 1/2

805-152C BENT PIN 3/8 X 2 1/2 USE W/COT

When making ﬁnal disposition of the old cylinders,

include with them the old lock sets:

CYLINDER LOCK CHANNEL-LONG and

BENT PIN 3/8 X 2 1/2 USE W/COT

59. Skip to “Position Cylinder Rod End” on page 13.

Figure 21

Left Arm New Cylinder

22561