Manual

This ElectriFly

™

Ultra E-Box was designed to use one or two

Hobbico

TorqMaster

™

LC sealed batteries (HCAP0800) or other

sealed batteries of the same size, and to fit the Great Planes

Triton

™

charger (GPMM3150) or the Hobbico Quick Field

Charger

™

MKII (HCAP0290). Fitting any other charger may

require modifications to the box.

❏ 1. Slide one or two sealed batteries into the battery

compartment. Connect the spade connectors to the batteries.

Note the polarity of the batteries (the red spade connectors go

with the red wires and positive battery terminals)

❏ 2. Replace the charge lead drawer. Cut four 3/4" x 3/4" [19mm

x 19mm] pieces of hook and loop material. Remove the protecting

tape on one side and apply them to the tabs in the battery

compartment. Remove the tape on the other side and position the

hatch. The hook and loop material will stick to the hatch.

❏ 3. Cut the battery wires on the chargers to the length desired

and solder banana plugs (HCAP0310) on them. Plug the

chargers in and slide them in place.

❏ 4. Stock your box with your flight accessories.

Optional: This wall can be removed to enlarge the compartments.

Get Your Box Ready to Use

Recommended Accessories

ULTRA

E-BOX

™

PAGE 1
™ ULTRA E-BOX Recommended Accessories tape on one side and apply them to the tabs in the battery compartment. Remove the tape on the other side and position the hatch. The hook and loop material will stick to the hatch. This ElectriFly™ Ultra E-Box was designed to use one or two Hobbico® TorqMaster™ LC sealed batteries (HCAP0800) or other sealed batteries of the same size, and to fit the Great Planes® Triton™ charger (GPMM3150) or the Hobbico Quick Field Charger™ MKII (HCAP0290).