User Manual

❏

2. Mount the motor with four M3x6 Phillips screws and a

small drop of threadlocker on the threads.The motor wires

should be oriented along the bottom of the fuselage.

❏

3. Assemble the folding propeller as shown. Fit the

propeller blades into the hub and then install the pins. The

locknuts should be just tight enough so the blades still

rotate freely on the pins.

❏

4. Apply a light  lm of oil to the colleted propeller shaft

so the spinner back plate will be easier to remove after the

prop nut has been tightened.

❏

Temporarily test- t the propeller/spinner assembly and

check the gap between the front of the fuselage and the

spinner back plate. The gap should be approximately 1-2mm.

Whenever removing the propeller assembly in the future,

do not tap or apply pressure to the front of the backplate.

Instead, insert a sheet of hard plastic or wood between

the spinner gap to push the backplate forward—it also

helps to sand a bevel to the edge of the plastic or wood

part so it can be wedged into the gap.

❏

6. Bevel the edges of the battery plate to conform to the

fuselage when in position.