Manual

7
❏ ❏ 8. Install the servo arm on the servo. Insert the Z-bend
end of a 3-3/8" [86mm] pushrod in the lower hole in the
aileron control horn. Insert the other end of the pushrod in
the quick connector. Install a 2 x 4mm machine screw in the
quick connector. Center the aileron and tighten the machine
screw on the pushrod. Trim the excess wire 1/4" [6mm] from
the quick connector.
❏ 9. Return to step 7 and install the pushrod on the
other aileron.
❏ 10. Install the rudder and elevator servos in the servo
cutouts in the aft end of the fuselage.
❏ 11. Connect the rudder servo to the receiver and center
the servo arm on the servo. Install the 8-3/16" [208mm]
pushrod in the outer hole of the rudder control horn. Follow
the same method to complete the installation as used for the
ailerons except install the brass quick connector in the hole
7/16" [11mm] from the center of the rudder servo arm.
❏ 12. Connect the elevator servo to the receiver and center
the servo arm on the servo. Install the 6-1/4" [159mm] pushrod
in the outer hole of the rudder control horn. Follow the same
method to complete the installation as before except install
the brass quick connector in the hole 1/2" [13mm] from the
center of the rudder servo arm.
INSTALL THE MAIN LANDING GEAR
❏ 1. Insert the main landing gear wire in the landing gear slot.
❏ 2. Insert the plywood landing gear retainer in the landing gear
slot. The rounded corners are inserted fi rst. If it fi ts loosely, use
a piece of tape (not included) to hold the retainer in position.