Manual

8
❏ 3. Slide a wheel onto the main landing gear wire. Insert
the wheel pant on the wire and apply a drop of foam-safe thin
CA to the wheel pant to secure it to the wire. Make sure to
not glue the wheel to the wire.
❏ 4. Install the other wheel and wheel pant on the main
landing gear.
MOTOR INSTALLATION
❏ 1. Position the RimFire 400 (28-30-950kV) brushless
motor on the motor mount with the wires down. Use the three
3 x 10mm sheet metal screws to mount the motor to the
motor mount. After tightening the screws, remove the screws
and motor and apply a couple of drops of thin CA to the
threads to harden the wood. After the CA has cured, reinstall
the motor.
❏ 2. Attach a piece of hook and loop material to the back of
the SS-12 brushless ESC. Route the motor wires through the
hole in the landing gear mount slot and connect the motor
wires to the motor. Route the battery and receiver plug up
through the opening in front of the wing. Attach an opposite
piece of hook and loop material to the bottom of the wing.
Attach the ESC to the hook and loop material on the bottom
of the wing.
❏ 3. Plug the ESC into the receiver. Use hook and loop
material to attach the receiver to the top of the wing, inside
the fuselage.
❏ 4. Before installing the propeller, temporarily plug the
motor battery into the ESC and check to see if the motor is
rotating in the correct direction.