Getting Started Guide

/
Step 7: Obtain a blood sample using the lancing device. Place the device against the pad of the finger.
The best puncture sites are on the middle or ring fingers. Press the release button. Remove the device
from the finger. Wait a few seconds for a blood drop to form. A minimum volume of 0.5 microliter is
needed.
Step 8: Apply the blood sample to the narrow end of the test strip until the meter beeps. If the blood
sample does not fill the confirmation window, an Er4 message may appear because of abnormal
viscosity or insufficient volume. If Er4 appears, retest with a new test strip.
Step 9: Remove the used test strip and safely discard it. After this, the Cellular Case will connect to the
BGM to sync the reading and send it to Omada. All of the lights on the Cellular Device will turn green,
signalling that all steps of the process were completed successfully.