User's Manual

43
Remote Control Operation
The Answering System can be operated through the HANDSET or away from
your home through a Tone telephone.
Remote Operation through the HANDSET
You can operate your Answering System via remote control using the
HANDSET.
1. Press the ANS.CONT button at STANDBY mode, to activate remote
control function.
2. Press the corresponding number of the function you wish to activate.
A. Press "2" to play messages.
B. While playing messages, press "1" to repeat or "3" to skip.
C. Press "4" to stop playing messages and go to the primary mailbox.
D. Press "5" to play continuously. See NOTE below since maximum time
for a remote control operation is 3 minutes.
E. Press "6" to record memo messages.
Press "6" again after your memo is completed.
F. Press "7" to play your OGM.
Press "77" to change your OGM.
Press "7" again to stop taking your OGM.
G. Press "9" to erase messages being played.
Press "99" to erase all messages in mailbox.
H. Press "8" to activate or deactivate the answering function.
I. Press " * " to activate the remote operation of Mailbox 1.
J. Press " 0 " to activate the remote operation of Mailbox 2.
K. Press " # " to activate the remote operation of Mailbox 3.
L. Press "TONE" to activate the remote operation of Mailbox 4.
NOTE: After the remote control function is activated, instruction code must
be entered within 3 minutes. If not, the HANDSET will beep for
10 seconds and then terminate the remote control operation. While
the HANDSET is beeping, press 5 (confirm) to continue remote
control function.
3. Press the ANS.CONT button to deactivate the remote control function
or place the HANDSET on the BASE UNIT.
Answering System Operation