User's Manual

Getting Started
BASE UNIT
TELEPHONE
CONNECTION
JACK
TONE/PULSE
SELECT SWITCH
TELEPHONE JACK
BASE UNIT
ANTENNA
120V WALL OUTLET
POWER-IN
SOURCE
AC ADAPTOR
TELEPHONE LINE CORD
3. Insert the small plug on the end of the AC adaptor into the POWER-IN connection
jack on the back of the BASE UNIT.
4. Plug the AC adaptor into a 120V AC wall outlet.
5. Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE
JACK and the other into the telephone line jack on the back of the BASE UNIT.
(If you have an older 4-prong telephone jack, you will need an RJ-11C
TELEPHONE JACK ADAPTOR. This adaptor is available at the same place you
purchased your telephone.)
6. Fully extend the antenna on the BASE UNIT for best reception.
7. We recommend not placing this unit next to appliances. Doing so may cause
interference.
8. TONE/PULSE Select Switch:
A. If your home is equipped with a touchtone dialing system, set the
TONE/PULSE select switch to the TONE position.
B. If you have a rotary dialing system, set TONE/PULSE select switch to the
PULSE position.
C. If you are unsure which system you have, set the TONE/PULSE select switch
to the TONE position. Press the TALK button on the HANDSET to get a
dial tone, and press any key on the keypad except the zero. If the dial tone
continues, you do not have touchtone dialing service. Press the TALK
button on the HANDSET to hang up. Set the TONE/PULSE select switch to
the PULSE Mode and try again.
9. Before initial use, charge the HANDSET for 12 hours.
IN USE/
BT LOW
25
CHANNEL
AUTOSCAN
TALK
OFF ON
CH
32
1
DEFABC
RINGER
Push the TALK button to confirm that you have a dial tone. If you
do not get a dial tone, review steps 3 through 8. If you still have no
dial tone, refer to the Problem Solving section on page 19.
9