Instruction Manual P/N: 12559004 Make: Honda Model: Accord Year: 2013-2014 Engine: V6-3.
• Please read the entire instruction manual before proceeding. • Ensure all components listed are present. • If you are missing any of the components, call customer support at 951-493-7100. • Ensure you have all necessary tools before proceeding. • Do not attempt to work on your vehicle when the engine is hot. • Disconnect the negative battery terminal before proceeding. • Retain factory parts for future use. Label A B C D E F G H I J K L M N O Qty.
D B C E L A Page 3 K O N FGHI M J GReddy.
REMOVAL 3 1 4 2 5 6 5 Figure A Refer to Figure A for steps 1-6 Note: Make sure car is cool before starting this installation to avoid coolant burns. Step 1: Pop off engine cover from grommets and remove engine cover 1 . Step 2: Disconnet the MAF sensor, and then remove the wire harness from the OE air box 2 . Step 3: Disconnect the crank case line from the OE tube 3 . Step 4: Loosen the clamp connecting the OE tube to the throttle body 4 . Step 5: Remove the two bolts holding the OE air box 5 .
REMOVAL 8 7 Figure B Refer to Figure B for step 7 Step 7: Disconnect the coolant hose connecting to your throttle body 7 and replace with the provided hose. (Have a shop towel or rag handy to catch any leaking coolant) Re-use your stock clamps. Disconnect the crank case line and remove the coolant hose/vacuum line assembly (This hose/metal tube will not be reused) 8 . NOTE: Make sure car is cooled down before disconnecting the coolant hose.
INSTALL 14 11 9 10 10 13 12 Figure C Refer to Figure C for steps 9-12 Step 8: Install the supplied nylon spacer onto the battery hold down 9 . Step 9: Install provided trim onto the edge of the GReddy housing. Place the GReddy housing into the vehicle as shown above 10 . Step 10: Secure housing to the battery hold down using washer and nut provide 11 and to the bottom factory mounting location using bolt and washer provided 12 .
INSTALL 15 16 Figure D Refer to Figure D for steps 13-14 Step 13: Remove the MAF sensor from the OE intake tube and install into the GReddy tube (Re-use the factory MAF screws and o-ring) Step 14: Install the GReddy filter onto the intake tube and tighten 16 . Page 7 15 . GReddy.
INSTALL 21 17 19 18 10 17 20 Page left blank intentionally Figure E Refer to Figure E for steps 15-22 Step 15: Install the GReddy intake tube onto the coupling and isolation mount 17 . Step 16: Re-connect the MAF sensor 18 . Step 17: Place the provided crank case hose onto the GReddy intake tube and valve cover 19 . Step 18: Install the provided nut and washer onto the isolation mount to secure tube 20 . Step 19: Tighten all clamps and nuts. Step 20: Re-install engine cover 21 .
J 12 Page left blank intentionally Page 9 L 11 GReddy.
Pro DRY S Air Filter P/N: 61-90131 To purchase any of the items above, view airflow charts, dyno graphs, photos, and video; please go to GReddy.com.
Page 11 GReddy.
GReddy Performance Products 9 Vanderbilt, Irvine CA 92618 TEL: 949.588.8300 • E-Mail:Tech@GReddy.