Instruction Manual P/N: 12519101 Make: Scion/Subaru/Toyota Model: FR-S/BRZ/86 Year: 2013 Engine: H4-2.
• Please read the entire instruction manual before proceeding. • Ensure all components listed are present. • If you are missing any of the components, call customer support at 949-588-8300. • Ensure you have all necessary tools before proceeding. • Do not attempt to work on your vehicle when the engine is hot. • Disconnect the negative battery terminal before proceeding. • Retain factory parts for future use. Label Qty.
D I E F A H G J B C Page 3 GReddy.
REMOVAL 4 3 2 4 1 2 1 1 5 5 5 5 Figure A Refer to Figure A for step 1-5 Step 1: Remove the three 10mm bolts on the OE housing 1 . Step 2: Unplug the MAF sensor and unclip the wire harness from the OE intake tube 2 . Step 3: Remove the crank case hose from the OE tube 3 . Step 4: Loosen the clamp off the throttle body and cabin sound chamber tube, then remove the OE intake system out of the vehicle 4 . Step 5: Remove the five 10mm bolts and two push clips on the front bumper rail 5 .
REMOVAL 6 6 7 6 6 Figure B Refer to Figure B for step 6 Step 6: Remove the three push clips on the driver side fender well also the one by the amber light 7 . Page 5 6 connecting to the bumper, and GReddy.
REMOVAL Figure C Refer to Figure C for steps 7 Step 7: With a flat head screwdriver push on the bottom side of the amber and pry out. Pop out the bottom side, then remove the rest of the amber light.
REMOVAL 8 8 Figure D Refer to Figure D for steps 8-9 Step 8: Gently pull the right side of the bumper to gain access to the OE scoop. Step 9: Remove the OE scoop off the vehicle by removing the two 10mm bolts 8 back on. Page 7 and install bumper GReddy.
INSTALL 10 Page left blank intentionally 9 9 Figure E Refer to Figure E for steps 10-13 Step 10: Remove two of the OE grommets off the OE housing that you removed in step one and install them on the housing (Refer to top right photo). Step 11: Install the large hose clamp onto the housing and air filter as shown (Refer to top right photo). Step 12: Install the Housing into the vehicle using the OE hardware 9 . Step 13: Place the silicone coupling onto the throttle body with the supplied clamps 10 .
INSTALL J L 12 11 Page left blank intentionally 13 Figure G Figure F Refer to Figure F for steps 14-18 (If you would like to use the sound chamber, Drill out the intake tube as shown in Figure G) Step 14: Install your intake tube into the vehicle. Step 15: Remove the MAF sensor off the OE air box and install onto the tube with the supplied hardware 11 . Step 16: Install the supplied rubber grommet onto the intake tube 12 and reinstall your factory crank case vent line.
Pro DRY S Air Filter P/N: TF-9019D To purchase any of the items above, view airflow charts, dyno graphs, photos, and video; please go to GReddy.com.
Page left blank intentionally Page 11 GReddy.
GReddy Performance Products 9 Vanderbilt, Irvine CA 92618 TEL: 949.588.8300 • Tech@greddy.
