Use and Care Manual

12
OPERATION OF WIRELESS REMOTE CONTROLLER
TRADITIONAL MODE - SLEEP 1
In Traditional Mode the unit will slowly relax the room set temperature by up to 4° F until
Sleep Mode is cancelled.
1
EXPERT MODE - SLEEP 2
In Expert Mode the unit will adjust the room set temperature at a rate based on the starting
set temperature value. Sleep Mode will continue until cancelled.
2
DIY MODE - SLEEP 3
You will be required to enter eight (8) room setpoint values for eight (8) hours of run time. The last
room setpoint value will be maintained until sleep mode is cancelled.
In Sleep Mode 3, press "Prog" button to enter setup mode. The remote controller will display “1:00”
in the time location. Use the “+” and “-“ buttons to select the desired room setpoint for the first hour
of run time. Then press the “Prog” button to save the setpoint.
The remote controller time display will change to “2:00.” Once again, use the “+” and “-“ buttons
to select the desired room setpoint for the second hour of run time, and press the “Prog” button to
again save the setpoint.
Repeat this sequence for the eight (8) room setpoint values. After all eight (8) values have been
entered, the remote controller will automatically revert to standard time and temperature display,
and the Sleep 3 Mode will begin.
At any time, you may press the “ON/OFF," " Mode," " Timer," "Sleep” or “Turbo" buttons to cancel
the Sleep 3 Mode.
Cooling Mode
Heating Mode
Cooling Mode Heating Mode