Use and Care Manual

18 19
OPERATION OF SMART CONTROL
COMMON NETWORK SETTING PROBLEMS
If local WiFi control fails, check the following items one by one:
•
Make sure electrical power is turned on to the outdoor and indoor units.
•
Make sure WiFi function is turned On as normal
•
Make sure your phone’s or tablet’s WiFi selects the corresponding Crown Indoor Wall Unit
•
Reset with the remote controller and then start setting again from step 3
NOTE: SmartPhones or tablets must be used within 25 feet of the Crown Indoor Wall unit.
TO RESET WiFi MODULE
Turn Crown unit Off with the remote controller and disconnect power to the unit. Re-connect
power, wait one minute, then press “WiFi” and “Mode” buttons simultaneously. When the
Crown unit emits a beep sound, WiFi module is successfully reset.
NOTE: “WiFi”, and Mode buttons must be pressed within two
minutes, or you will need to repeat the process.
SMART CONTROL FUNCTIONS
Mode: Select “Auto”, “Cool”, “Dry”, “Fan” or“Heat.”
See Remote Controller instructions for detailed operation
of these modes.
Temperature: Room temperature setting can be selected
by scrolling to the desired room temperature icon.
Fan Speed: Fan Speed can be adjusted by selecting the fan
icon and then selecting the speed. See Remote Controller
instructions for detailed operation.