MSDS

Material Safety Data Sheet
Genetron® 410A
Version 2 Revision Date 10/04/2010 Print Date 04/13/2012
Page 5 / 13
flame or any incandescent material.
Do not remove screw cap until immediately ready for use.
Always replace cap after use.
Advice on protection
against fire and explosion
: The product is not flammable.
Can form a combustible mixture with air at pressures above
atmospheric pressure.
Storage
Requirements for storage
areas and containers
: Pressurized container: Protect from sunlight and do not expose
to temperatures exceeding 50 °C. Do not pierce or burn, even
after use.
Keep containers tightly closed in a dry, cool and well-ventilated
place.
Storage rooms must be properly ventilated.
Ensure adequate ventilation, especially in confined areas.
Protect cylinders from physical damage.
Store away from incompatible substances.
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Protective measures : Do not breathe vapour.
Avoid contact with skin, eyes and clothing.
Ensure that eyewash stations and safety showers are close to
the workstation location.
Engineering measures : General room ventilation is adequate for storage and handling.
Perform filling operations only at stations with exhaust
ventilation facilities.
Eye protection : Wear as appropriate:
Safety glasses with side-shields
If splashes are likely to occur, wear:
Goggles or face shield, giving complete protection to eyes
Hand protection : Leather gloves
In case of contact through splashing:
Protective gloves
Neoprene gloves
Polyvinyl alcohol or nitrile- butyl-rubber gloves
Skin and body protection : Avoid skin contact with leaking liquid (danger of frostbite).
Wear cold insulating gloves/face shield/eye protection.
Respiratory protection : In case of insufficient ventilation wear suitable respiratory