ETAC Product Data Guide

10
13
COASTAL PROTECTION
A09078
Corrosion Pro tection
GA
NOTE: Refer to the product warranty for reduced
warranty coverage on standard non-corrosion
protected units installed within one mile of the of the
sea coast or within a corrosive environment.
The Gree Coastal E-TAC features a corrosion-resistant
coating that exceeds the performance and protection
of other products of this kind on the market. The
coating pro
vides salt air corrosion protection
g
iving you added reliability in your business.
Install the best in corrosion protection for your
property, without the worry of performance
degradation, coating breakdown or shortened life.
Gree’s Coastal Units are made with a blue-colored
anti-corrosion epoxy treated to resist corrosion. This
technology maintains excellent heat transfer
properties while extending the coil life against
damage from salt air and salt water in seacoast
installations. This is a tough epoxy coating that
uniformly covers the outside coil surface with a thick
.5 to 1.0 mil layer of protection. This advanced
material is highly flexible, eliminating cracking
problems with traditional coatings and dipped coils.
COASTAL PREMIUM PROTECTION
• Condenser Coils are coated with a corrosion
resistant epoxy resin providing enhanced
resistance to acidic and salt air conditions.
• 1500 hr salt spray tested.
• Durable non-corrosive fan wheel and shroud.
• Added protection with durable powder coated paint.
• All exposed fasteners manufactured of high quality
stainless steel.
C
e
r
t
i
f
i
e
d
S
e
a
c
o
a
s
t
P
r
o
t
e
c
t
i
o
n
APPLICATIONS
• Hotels and motels
• Nursing homes and assisted living care
centers
• Offices
• Apartments
• Single--family dwellings
• Home conversions and residential add--ons
NEW CONSTRUCTION
ADVANTAGES FOR NEW
CONSTRUCTION
Design Flexibility for the Architect/Engineer
• Whisper--quiet performance, indoors and out
• No bulky duct system
• No separate equipment room
• No water towers or additional cooling
equipment
• No complex match--up of different HVAC
components
• Less sensitivity to building orientation (sun,
wind, shade)
• Optional architectural grille to permit custom
exterior appearance
I nitial Cost Savings for the Buildin
g Owner
• No
expensive component HVAC system
purchase
• No equipment room or maintenance
engineering staff
• Two--part delivery to minimize on--site
damage
• Weather--protected wall sleeve that goes in
place during construction; chassis that slides
in place after construction
• No seasonal changeover required for cooling
or heating -- units are self--contained comfort
systems
Lower Operating Costs and Reliable Comfort
for The Occupant
• Heat pump models offer substantial savings
over models with conventional electric
resistance heaters
• Individual units allow tenants to choose the
degree of comfort and operating economy.
• Rapid
servicing reduces downtime: complete
chassis can be replaced in minutes without
disrupting other occupants.
• Each unit operates independently of other
units in the building. No dependency by
building on central HVAC system.
RETROFIT/REPLACEMENT
If you are replacing a unit in an existing wall sleeve,
your options include:
• Replace the existing wall sleeve with the
the polymer wall sleeve. See accessory sleeve
section for selecting the correct sleeve for
your application.
NOTE: in most cases, when replacing the
wall sleeve, the exterior grille must also be
replaced.
• Use an existing sleeve and exterior grille. The
Gree E-TAC will fit into:
—
— Friedrich T series and ZoneAire wall
sleeves, with a required wall sleeve
extension (see acce
ssory Friedrich
Retrofit Wall Sleeve Adapter).
E-TAC
Whether you are designing a new structure or
replacing packaged terminal air conditioning units in
an existing building, Gree E-TAC will meet your
needs.
The Gree E-TAC Packaged Terminal Air Conditioning
(E-TAC) unit is designed to meet the needs of the
architect, engineer, and contractor. For unit
installation, Gree’s expert support network will assist
in all applicable aspects of the construction project,
from preparing a budget to start-up.
4
The following major competitors’ wall
sleeves/grilles: Carrier, GE, Amana,
Trane, Friedrich and Bryant, and NO
accessory retrofit kit is required.