User Manual

1.Stick one accordion panel seal respectively on the left side and right side
of accordition panel installation frame, as shown in the figure.
top mounting rail
top mounting rail seal strip
Step 1: Install top mounting rail
1. Tear off the paster at back side of top mounting rail seal strip, and then
align it at the bottom edge of top mounting rail to stick the top mounting rail
rseal strip at the bottom of top mounting rail. (The top mounting rail seal strip
has been stick on the top mounting rail for some models. Therefore, this step
can be omitted.)
Step 2:Install accordion panel
Installation procedure
23
models. Therefore, this step can be omitted.)
2. Use 4 type A screws to fix the top mounting rail at the outer case of air
condition. (The top mounting rail has been fixed on the conditioner for some
“RIGHT”at both sides of air conditioner in turn. Slide the upper and lower ends
2. Undraw the accordion panel, install the accordion panel marked with “LEFT”、
of accordion panel into top mounting rail and lower guide rails.
How to install:

Choose a location where there are no
any obstacle surrounding the unit,
and the plug is accessible.
 
cording to the following diagram.
Over
1500 mm
500mm 500mm
300mm
300mm
Location
The distance between the air condition er
and the around obstacles should meet the
requirement as below: over 300mm
(upper side), over 500mm (left side),
over 500mm (right side), over 1500mm
(front side) and over 500mm (rear side).