Use and Care Manual
10
Table 4.3 Unit: mm(inch)
Item
Model
A B C D E F
UMAT48HP230V1AC
1040
(41)
910
(35-7/8)
842
(33-1/8)
788
(31)
170
(6-3/4)
290
(11-3/8))
4.1.2 Installing the Suspension Bolts
(1). Using the installation template, drill holes for bolts (four holes). (Fig. 4.2)
(2). Install the bolts to the ceiling at a place strong enough to hold the unit. Mark the bolt
positions from the installation template. With a drill, drill four 12.7mm (1/2inch)
diameter holes. (Fig. 4.3)
(3). Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor
bolts with a hammer. (Fig. 4.4)
U-match Series Cassette Type Unit
12.7mm(1/2inch)
60 to 70mm
(2-3/8 to 2-3/4inch)
Fig. 4.2 Fig. 4.3 Fig. 4.4
4.1.3 Installing the Main Body Unit
Fig. 4.5
(1). Install the hoisting stand on the hoisting screw by using nuts and gaskets at both upper
and lower sides of the hoisting stand. To prevent the gasket from breaking off, a gasket
anchor board can be helpful.