Service Manual

U-Match Series DC Inverter Service Manual
137
Disassembly of right and
left finishing plates
Disassemble the screws as shown in the
graph with screwdriver and then push
upward to remove the right and left finishing
plates. (As is shown in the graph, arrow
represents the position of screws.)
Disassembly of panel parts
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly. Do not
scratch the outer parts.
Step
Illustration
Handling Instruction
Disassembly of panel
parts
Unscrew the 3 sides’ screws on the cover
to remove the cover.
Disassembly of sub-assy of electric box
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly,
especially the components inside the box in case of water and hit.
Step
Illustration
Handling Instruction
Disassembly of electric
box cover
Disassemble 3 screws as shown by the
arrow in the graph on left and remove the
electric box cover.
Disassembly of air deflecting plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly, especially
the joints of the air deflecting plate.
Step
Illustration
Handling Instruction
Disassembly of sub-assy
of air deflecting plate
Remove the air deflecting plates from the
air deflecting plate support assembly, and
then remove both ends from the air
sweeping motor. joint (As is shown in the
graph, arrow represents the support
assembly and circle the air sweeping
motor joint.)
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step
Illustration
Handling Instruction
Disassemble of
water-containing plate
modules
Remove the water-containing plate modules.