Service Manual

Table Of Contents
U-Match Series DC Inverter Service Manual
139
3. Disassembly of bearing
fixing plates
Unscrew the 3 screws and 2 nuts of support
to remove the mounting support.
4. Disassembly of motor
Loosen the 2 screws of the motor attaching
clamp, remove the motor attaching clamp
and motor attaching clamp subassembly to
remove the motor.
Disassembly of right and left fixing plates
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly.
Step
Illustration
Handling Instruction
Disassembly of right and
left fixing plates
Disassemble the bolts on right and left fixing
plates with tools. (As is shown by the arrow in
the graph.)
Model: GTH18D3FI/GTH24D3FI/GTH48D3FI
Disassembly of panel grating module
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly. Do not
put filter screen near the high temperature heat source.
Step
Illustration
Handling Instruction
Disassembly of sub-assy
of front grill
1. Unscrew the 2 clasps of the upper grill and
the 2 screws of the clasps.
2. Open the grill, disassemble the 2 down
clasps to remove the grill.
Disassembly of right and left finishing plates
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly. Do not
scratch the outer parts.
Step
Illustration
Handling Instruction
Disassembly of right and
left finishing plates
Disassemble the screws as shown in the
graph with screwdriver and then push upward
to remove the right and left finishing
plates.(As is shown in the graph, arrow
represents the position of screws.)