Manualshelf

Quick Start Guide

ManualsBrandsGree ManualsAir ConditionersSlim Duct Indoor Unit with 39500 BTU Cooling Capacity, 44000 BTU Heat Capacity, Wired Controller and Internal Condensate Drain Pump in Stainless Steel
12
M
ULTI FAN SPEEDS
W
hether operating in either Cooling or Heating mode, the indoor fan can be set to your choice of speeds (Low, Medium, High or Auto)
t
o achieve maximum comfort.
X-FAN MODE
In humid areas, this function allows indoor fan to run for a pre-determined time after unit is turned off (in cooling or dry modes) to remove
additional moisture from coil.
DRY MODE
Indoor fan runs at low speed and turns off when desired temperature is reached.
CONDENSATE SENTRY
Overflow of the condensate pan is prevented. The system automatically shuts off when the condensate level is too high.
INTELLIGENT DEFROST
This increases room comfort and saves energy by sensing the need for defrosting and eliminating unnecessary defrost cycles.
POWER FAILURE MODE
Your settings and parameters are stored in non-volatile memory and are retained during a power failure.
BUILT-IN CONDENSATE LIFT PUMP
This pumps condensate from the basepan to the drain system.
SLEEP MODE
You design a cycle to automatically adjust room temperatures during your sleep time, to maximize comfort and reduce utility bills.
TURBO MODE
When you wish to achieve the desired room temperature in the shortest possible time, Turbo Mode runs the unit at ultra high speeds for
quickest results.
TIMER MODE
Unit can be programmed to turn ON or OFF, adjustable between one half and 24 hours.
INTELLIGENT PRE-HEATING
In heating mode, the system delays fan activation until the coil has warmed up, to prevent blowing uncomfortable cool air into the room.
SELF-DIAGNOSIS
The built-in computer uses real-time diagnostics to continuously scan for errors or malfunctions. Fault codes are shown on the unit display
to facilitate troubleshooting.
KEY FEATURES & FUNCTIONS
FAQs
Why does the fan continue to run even when the unit is not cooling or heating?
To maintain consistent temperatures and minimize energy-loss from constant starts and stops, the fan keeps air flowing past the thermostat.
What temperature is displayed on the wall-mounted Wired Tether Controller?
The controller always displays desired room temperature.
How often should I clean the air filters?
It is recommended that air filters be cleaned every three months to maintain peak performance and enhance the life of the unit.
Not all features available on all models. Your actual system and related devices may differ from the images shown in this manual.
Specifications are subject to change without notice. Manufacturer reserves the right to discontinue, or change at any time,
specifications or designs without notice or without incurring obligations. ©2015. All rights reserved.
For complete instructions on these and other functions,
as well as important safety information, see the Owners Manual.
For more information, visit GreeComfort.com.