Specifications

GREEN ENERGY BATTERY Co.,LTD
Page 17 of 21
10.FCC Statement FCC 声明
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and 2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement, the device can be used in
portable exposure condition without restriction.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
该设备符合FCC 规则的第15 部分。操作应符合以下两个条件
：1) 该装置不会造成有害的干扰，
并且2) 该设备必须接受任何干扰，包括可能导致不希望的操作的干扰。
未经当事人明确认可的变更或修改可能会影响你操作设备的权限。
该装置已被评估以满足一般的射频曝光要求，该装置可在不受限制的便携式曝光条件下使用。
注：本设备已经过测试，根据FCC 规则的第15 部分，符合B 类数字设备的限制。这些限制旨在
为住宅安装中的有害干扰提供合理的保护。
这种设备会产生、使用和发射无线电频率能量，并且，未按照规定安装使用的，可能对无线电通
信造成有害干扰。然而，不能保证在特定的安装中不会发生干扰。如果该设备确实对无线电或电
视接收造成有害干扰，这可以通过关闭和开启设备来确定，则鼓励用户尝试通过以下措施中的一
个或多个来校正干扰：
调整接收天线的方向或位置。
加大设备和接收器之间的距离。
将设备连接到与接收器连接的电路不同的电路插座上。
咨询经销商或有经验的广播/电视技术人员寻求帮助。