User's Manual

greenpacket confidential
Quick Installation Guide (Rev. 1.0)
Metal Strap
Hardware Setup
Connect the Outdoor CPE Device to WN-200 or Passive PoE injector unit:
Connect WN-200's WAN port, or RJ-45 port (marked as ODU) of PoE injector, to
ODU's RJ-45 port by using standard Ethernet cable. (Note 1.)
Connect PC to WN-200 or PoE injector for configuring Outdoor CPE Device:
Connect WN-200's LAN, or PoE injector's LAN port, to computer by using the device
cable.
Connect WN-200 or PoE injector to the power source
Power on ODU
-
-
-
Put the power adaptor plug into the DC jack of WN-200 or PoE injector
Plug the power adaptor to the electrical outlet
When ODU is powered on, “Power LED” (on back side of top cover) will be
solid on.
Note 1: In ODU package, WN-200, PoE Injector, Ethernet cable is NOT included.
Warning! Please use standard Ethernet (UTP, unshielded twisted pair) cable to install ODU.
Use PC to configure the ODU