User's Manual

98
4. Tighten the screws to secure the Outdoor CPE Device tightly.
It is not necessary to use Arm Bracket for pole-mounting. Arm Bracket is only used for wall-mounting.
Nut
Bracket W/L Tab
Bracket with Tab
Flat washer
Split washer
Screw (60mm)
Screw (35mm)
Nut
Flat washer
Split washer
Lockwasher
Figure 68 Pole-Mount the Outdoor CPE Device
Wall-Mounting the Outdoor CPE Device
In the following steps, it introduces how to wall-mounting the Outdoor CPE Device.
1. Install the Bra cket with tab on a wall b y usi ng t wo mou nting scre ws appr opriate for the wall’s con struction m aterial. T he ap propriate
mounting hardware should be purchased directly from a local supplier.
2. Connect the Arm Bracket to Outdoor CPE Device with the 35mm length Screw, Lockwasher, Split washer, Flat washer, and Nut orderly as
shown in Figure 69. Ensure the Lockwasher is located between the Bracket’s tab and the Outdoor CPE Device’s tab. Do not over-tighten
before finishing the Outdoor CPE Device alignment.
3. Secure the other side of Arm Bracket along with Lockwasher to the Bracket’s tab mounted on wall. Ensure that the bolt head is positioned in
the socket of the Bracket. Do not over-tighten before finishing the Outdoor CPE Device alignment.
4. Adjust the azimuth and elevation of the Outdoor CPE Device toward the direction of WiMAX Base Station location.
5. Tighten the screws to secure the Outdoor CPE Device tightly.
Nut
Flat washer
Split washer
Lockwasher
Arm Bracket
Customer supplied screw
Nut
Flat washer
Split washer
Screw (35mm)
Bracket with Tab
Screw (35mm)
Customer supplied screw
Lockwasher
Figure 69 Wall-Mount the Outdoor CPE Device
Grounding the Outdoor CPE Device
Grounding the Out door C PE Device is e ssential to a void serious i njury to ser vice pers onnel an d damage t o t he Outdoor CPE Device. T he
following steps introduce how to ground the Outdoor CPE Device.
1. Remove the ground screw installed on the side of the Outdoor CPE Device, as shown in Figure 70.
2. Cut the required length of the ground wire, and then strip the insulation from the ground wire by using either a wire cutter/stripper or utility
knife.
3. Crimp the ground wire to the copper cable lug, and then connect the cable lug to the grounding connection on the side of the Outdoor CPE
Device. Please be noted that the thickness of the cable lug should be less than 0.85mm.
4. Tighten the screw by using the appropriate size and type of screw driver to secure the copper cable lug to the Outdoor CPE Device.
5. Strip the other end of the ground wire and connect to the main ground.