Replacement Part List

Owner’s Manual

Installation

NOTE: PRIOR TO POWERING TOOLS AND EQUIPMENT MAKE SURE THE

GENERAT OR’S RATED VOLTAGE, WATTAGE AND AMPERAGE CAPACITY IS

ADEQUATE TO SUPPLY ALL ELECTRICAL LOADS THAT THE UNIT WILL

POWER. IF POWERING EXCEEDS THE GENERATOR’S CAPACITY, IT MAY BE

NECESSARY TO GROUP ONE OR MORE OF THE TOOLS AND/OR EQUIPMENT

FOR CONNECTION TO A SEPARATE GENERATOR.

Electrical and other permits may be required for the installation of emergency power systems.

Investigate your local building and electrical codes before installing this unit. Installation must be

completed by licensed contractors.

WARNING! THE GENERATOR WEIGHS APPROXIMATELY OVER 100 POUNDS.

USECAREANDTHEPROPERLIFTINGORHOISTINGEQUIPMENTWHEN

MOVING IT TO THE INSTALLATION LOCATION. ALWAYS CONNECT HOIST

LINES TO THE FRAME OF THE GENERATOR.

General Location

• Make sure to locate and install the generator outdoors where cooling air is readily available.

• Install the generator so that the air inlets and outlets are not blocked by obstructions such as

bushes, trees, or snow drifts. Locating it in the path of heavy winds or snowdrifts may require the

placement of a barrier for protection. In normal weather conditions, the air vent should face the

prevailing wind direction.

• Install the generator on a concrete

slab or other area where rain drainage or flood waters can not

reach it.

• Generator placement should allow four feet of access to all sides for maintenance.

• Place the generator as close as possible to the electrical tools and equipment being powered to

reduce the length of extension cords.