Other Content

PARTS LIST

Use only with the proper sized EMT conduit.

Do not use with IMC or rigid conduit.

Damage to the tool will result.

The locations of knockouts in metal boxes vary. It may

be necessary to adjust the offset to match the knockout.

This tool can achieve a maximum offset of 0.56" (9/16)

with full handle actuation. For a smaller offset, reduce

the amount of handle actuation.

For best results, mount the bender to a bench top or

similar surface. Use the mounting holes provided.

Little Kicker is a registered trademark of Textron Innovations Inc.

End of conduit

should stick out of the

low side of the dies.

1810 and 1811

Little Kicker

Hand Benders

for 1/2" and 3/4" EMT

Serial Codes ACD and ACE

PAGE 1
PARTS LIST 1810 and 1811 Little Kicker Hand Benders ® for 1/2" and 3/4" EMT Serial Codes ACD and ACE Use only with the proper sized EMT conduit. Do not use with IMC or rigid conduit. Damage to the tool will result. The locations of knockouts in metal boxes vary. It may be necessary to adjust the offset to match the knockout. This tool can achieve a maximum offset of 0.56" (9/16) with full handle actuation. For a smaller offset, reduce the amount of handle actuation.
PAGE 2
1810 and 1811 Hand Benders 5 4 9 6 7 8 11,12 1 15 1810 Key Part No. 1811 Part No. Description Qty 1 50030116 50022679 Die, upper........................................................1 2 50030108 50022660 Die, lower.........................................................1 3 50043196 50043196 Link..................................................................2 4 50043226 50043226 Handle, weldment...........................................1 5 52055243 52055243 Grip, rubber....