Install Instructions

Greenlee Tools, Inc.
2
Punches for Manual Tool Use
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This manual and any
markings on tools provide information for avoiding
hazards and unsafe practices related to the use of this
tool. Observe all of the safety information provided
Purpose of this Manual
This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tool:
Punches for Manual Tool Use
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge at www.greenlee.com.
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
All specications are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Quick Draw and Slug-Buster are registered trademarks of
Greenlee Tools, Inc.
KEEP THIS MANUAL
Table of Contents
Description ..................................................................... 2
Safety ............................................................................. 2
Purpose of this Manual .................................................. 2
Important Safety Information ..................................... 3–4
Punch, Die, and Drawstud Selection .............................. 5
Description
Greenlee punches are cutting tools for punching holes
in a variety of materials and material thicknesses. These
punches are intended to be used with Greenlee dies,
drawstuds, and knockout drivers.
This tool is designed to be used with the following
Greenlee accessories:
• Ratchet Wrench
Standard, Slug-Buster
®
, Electronic Connector Panel
Punches, and special shape punches can punch holes
through mild steel, brass, copper, aluminum, berglass,
and plastics, with limited stainless steel capability.
Do not exceed the rated capacity of the punch. Ensure
your manual punch driving setup meets the required
capacity before attempting to punch a hole.