Installation Manual

GMX Modular Materials Cart System
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
9
Assembly Instructions
1. Refer to “Quick Connect Accessories” for frame end
installation.
2. Cross arms must be placed inside retaining brack-
ets on top of retaining pins.
Note: Fasteners supplied with frame ends may be
used to obtain permanent assembly.
3. Position spindles on cross arms and secure with
fasteners.
Note: Position spindles as shown in assembled view
to achieve standard capacity rating. Add, remove, or
reposition spindles on cross arms to achieve desired
capacity.
4. Position wire guide over any 1 x 2 structure and
secure with fasteners provided.
5. Optional extended spindles may be positioned on
top cross arm to increase capacity to 14 spools of
ø18" x 14.2" wide. Use fasteners to secure.
Specifications
Height .................................................. 37.0" (939.8 mm)
Width ....................................................31.5" (800.1 mm)
Length ...............................................63.5" (1612.9 mm)
Weight ....................................................84.5 lb (38.3 kg)
Capacity (without
optional spindles) ................... 10 ø18" (457 mm) spools,
14.2" (360.2 mm) wide,
125 lb (56.7 kg) per spindle
Parts List
Key Part No. Description Qty
1 Frame end .............................................2
2 Cross arm .............................................2
3 Wire guide ............................................. 1
4 52066292 Spindle .................................................. 5
5 52066293 Spindle, extended ................................. 0
6 Bolt, 1/4-20 x 2 carriage .......................9
7 Washer, 1/4 at .....................................9
8 Nut, 1/4-20 Nylock ................................9
9 Nipple, 1/2" conduit ............................ 14
10 Locknut, 1/2" conduit steel .................14
11 50223003 Grip .......................................................2
12 52065801 Cap plug, 1 x 2 rect. .............................6
13 52065612 Decal, identication ..............................2
GMX-910 Wire Dispenser
5
(optional)
3
9, 10
11
6, 7, 8
2
1
13
12
4
11.0" (279 mm)
21.0" (533 mm)
Wire Guide
Spindle
Cross Arm
Retaining Bracket
Frame End
Retaining Pin
Note: Wire guide
must be bolted
to end frame.
Note: All spindles
must be bolted
to cross arms.
Note: Cross arm end tabs
must be retained by pin
on bottom and bolt on top.