Textron Inc., a subsidiary of Textron Inc. Electric Toothbrush User Manual

Priming

Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore the full stroke

after considerable use, when the stroke may be reduced and fasteners are not fully placed by one operation of the trigger.

The recommended oil for priming is Hyspin

VG32 available in 0.5 litre (part number 07992-00002) or one gallon containers (part number

07992-00006). Please see safety data below.

First Aid

SKIN:

Wash thoroughly with soap and water as soon as possible. Casual contact requires no immediate attention. Short term contact requires no

immediate attention.

INGESTION:

Seek medical attention immediately. DO NOT induce vomiting.

EYES:

Irrigate immediately with water for several minutes. Although NOT a primary irritant, minor irritation may occur following contact.

Fire

Flash point 232°C. Not classiﬁed as ﬂammable.

Suitable extinguishing media: CO

, dry powder, foam or water fog. DO NOT use water jets.

Environment

WASTE DISPOSAL: Through authorised contractor to a licensed site. May be incinerated. Used product may be sent for reclamation.

SPILLAGE: Prevent entry into drains, sewers and water courses. Soak up with absorbent material.

Handling

Wear eye protection, impervious gloves (e.g. of PVC) and a plastic apron. Use in well ventilated area.

Storage

No special precautions.

To enable you to follow the priming procedure opposite, you will need to obtain a priming kit:

PART Nº DESCRIPTION

PRIMING KIT : 07900-00688

07900-00351 3mm ALLEN KEY

07900-00700 PRIMING PUMP

07900-00224 4mm ALLEN KEY

Oil Details

Hyspin

VG 32 Oil Safety Data

Priming Kit

Inc.