Installation & Assembly

Installation in Stucco or Concrete

There are 2 options for installing in this type of surface

1. Directly in Surface

2. Attached to Mesh

Directly in Surface

Tools needed:

 Concrete nails 1” or 1 1/2 "

 Hammer or air compressor.

1. Snap panels together where the is, assembling a column the size of the

surface´s height.

2. Make sure that the assembly of the panels is uniform and connectors all

match the same side.

3. Hang the line of panels using concrete nails from the top and middle where

the green marks are

4. Nail the rest of the line of panels randomly as needed so they are firmly

attached to the wall.

5. Repeat step 1 and snap the new line to previously installed line of panels

where is.

6. Repeat Steps 3 and 4 nailing where needed

7. Continue until the whole area is covered and ready.

PAGE 1
Installation in Stucco or Concrete There are 2 options for installing in this type of surface 1. Directly in Surface 2. Attached to Mesh Directly in Surface Tools needed:  Concrete nails 1” or 1 1/2 "  Hammer or air compressor. 1. Snap panels together where the is, assembling a column the size of the surface´s height. 2. Make sure that the assembly of the panels is uniform and connectors all match the same side. 3.
PAGE 2
Attached to Mesh Tools needed:  Drill or Air Compressor  Mesh  Zip Ties 1. Install mesh in the whole surface you are installing the product using a drill or air compressor. 2. Snap panels together where the is, assembling a column the size of the surface´s height. 3. Make sure that the assembly of the panels is uniform and connectors all match the same side. 4. Hang the line of panels using zip ties from the top and middle where the green marks are 5.