Automobile Air Purification Owner’s Manual
WELCOME Thank you for your purchase of the pureAir MOTION. The technology in the unit is designed to clean your vehicle’s breathing space of smoke, bacteria, viruses, VOC’s (Volatile Organic Compounds), dust and other particulates. With minimal cleaning and maintenance, you can keep MOTION in its optimal working condition.
TABLE OF CONTENTS 3 Uses & Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Product Introduction / Control Panel and Unit Top. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Product Introduction / Unit Rear . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
USES & FEATURES NOTE: MOTION is not a medical device and should not be used to alleviate any respiratory issues you may have. Please consult your doctor before using the MOTION if you are worried that the machine could cause adverse effects.
WARNINGS 5 NOTE: For your safety, please read through these warnings before using MOTION. Do not change settings on the unit while driving. Do not place in a location that will obstruct your view while driving. Do not block either air vent. Be careful with liquids near the unit. Unplug this unit before cleaning or maintenance. Unplug this unit when not in use. Mechanical or Electrical Maintenance must be performed by the manufacturer or licensed professional.
PRODUCT INTRODUCTION / Control Panel & Unit Top 1 Air Vent Out 2 Mode/Fan Speed 3 Fan Speed Indicator 4 Ion Generator Replacement Light 5 Ion Generator Lifetime Reset 6 Clean Filter Light 2 3 1 5 4 6
PRODUCT INTRODUCTION / Unit Rear 7 7 Ion Generator 8 DC Power Plug In 9 Filter 10 DC Power Adapter 7 8 10 9 Copyright © 2017 GreenTech Environmental, LLC.
SETUP Push the Rear Unit Cover down until it clicks and slide the Cover off the unit. Place the DC Plug in the DC Power Plug In and situate the cord in one of its two cable ports along the side of the unit. Replace the Rear Unit Cover.
SETUP 9 Secure the Power Plug into the Vehicle’s 12V Outlet. Place the unit in a cup holder or another secure location that will not distract the driver. Copyright © 2017 GreenTech Environmental, LLC.
OPERATION NOTE: To improve the Ion Output, use MOTION in conjunction with your vehicle’s Air Conditioning. WARNING: Do not change settings on MOTION while driving your vehicle. Push the Mode Button once. The unit will now run in Low Output Mode. (Denoted by One Arrow on Fan Speed Indicator) Pushing the Mode Button again will change to High Output Mode.
OPERATION 11 Pushing the Mode Button a third time will turn the unit OFF. NOTE: MOTION will save the last mode used when you turn your car OFF and back ON. NOTE: MOTION has an automatic shut-off feature that will power the unit down after 4 hours; this is to prevent a battery drain if your outlet is not controlled by the vehicle’s ignition. Copyright © 2017 GreenTech Environmental, LLC.
MAINTENANCE Your MOTION will need maintenance from time to time in order to keep it functioning at its best ability. WARNING: Remove the Power Plug from the Vehicle’s 12V Outlet before performing any maintenance. Failure to do so could result in an electrical shock. Ion Generator Replacement Indicator - 16,000 Hours Estimated Lifetime The Ion Generator Replacement Indicator will light up to notify you if the Ion Generator is damaged or in need of replacement.
MAINTENANCE 13 Remove the screw holding the Ion Generator in place. Disconnect the Power Cable and Remove the Ion Generator. Replace the Ion Generator and the Screw that holds it in place. Copyright © 2017 GreenTech Environmental, LLC.
MAINTENANCE (continued from page 13) Replace the Rear Cover and plug the unit back into the Vehicle’s 12V Outlet. 6 Turn the MOTION on and hold the Reset Button for 3+ Seconds. The Ion Generator Indicator Light will flash twice, turn off, and begin monitoring the new Ion Generator.
CLEANING 15 Your MOTION will need cleaning from time to time in order to keep it functioning to its best ability. WARNING: Remove the Power Plug from the Vehicle’s 12V Outlet before performing any cleaning. Failure to do so could result in an electrical shock. WARNING: Damage may occur while using harsh chemical cleaners to clean your unit. For best results, use a damp towel to wipe the unit down. Push the Rear Unit Cover down until it clicks and slide the Cover off the unit.
CLEANING (continued from page 15) Dry and replace the Rear Cover. Turn the MOTION on and hold the Reset Button for 3+ Seconds. The Clean Filter Indicator Light will turn off.
PRODUCT SPECIFICATIONS 17 Model Number PA-MOTION Voltage 12V DC | .14 A Effective Area 3.6 m3 Dimensions 6.4” H (162 mm) x Weight 8.64 oz. (245g) Modes High Low Electrical Usage 2.3 W 1.8 W Ion Output 25,000 Ions/cm3 7,000 Ions/cm3 2.8” W (72 mm) x Copyright © 2017 GreenTech Environmental, LLC. | All Rights Reserved 2.
WARRANTY INFORMATION LIMITED WARRANTY INFORMATION Your pureAir MOTION (Product) is warranted to be free from all defects in material and workmanship in normal household use for a period of 1 Year from date of purchase. The warranty is granted only to the original purchaser. The warranty is subject to the following provisions: Any damages or malfunctions caused by negligence, abuse, or use not in accordance with the Product Owner’s Manual are not covered by this warranty.
NOTES 19 ______________________________________________________________________________________________ ______________________________________________________________________________________________ ______________________________________________________________________________________________ ______________________________________________________________________________________________ ______________________________________________________________________________________________ ____________________________
www.GreenTechEnv.