Owners Manual

7
Turn the Master Switch ON
• Activate pureHeat WAVE by ipping the MASTER SWITCH on the rear bottom to “-”.
• Deactivate pureHeat WAVE by ipping the MASTER SWITCH to “O”.
• To save energy, unplug pureHeat WAVE when not in use.
Turn pureHeat WAVE ON/OFF
• Turn the unit ON by pressing the POWER BUTTON or any button on the CONTROL PANEL.
• Turn the unit OFF by pressing the POWER BUTTON on the CONTROL PANEL.
pureHeat WAVE will start in MEDIUM HEAT MODE with HIGH FAN SPEED. Unless the MASTER
SWITCH is turned OFF or the power is interrupted, pureHeat WAVE will return to the most
recently used settings whenever it is turned on.
Set the Temperature
• Press the MODE BUTTON to cycle through LOW HEAT, MEDIUM HEAT, HIGH HEAT, and
COOL COMFORT (fan only) levels.
• LOW HEAT MODE (1 RED Light) - Temperature set to 66˚
• MEDIUM HEAT MODE (2 RED Lights) - Temperature set to 72˚
• HIGH HEAT MODE (3 RED Lights) - Temperature set to 78˚
• COOL COMFORT MODE (BLUE Lights) - FAN ONLY
pureHeat WAVE has a temperature sensor and will enter STANDBY MODE when the
temperature in your space has exceeded the set temperature by 2 Degrees. When the
Room drops 2 Degrees below the set temperature, the heater will resume normal operation.
QUICK START
Getting pureHeat WAVE to keep you warm is simple and intuitive but it is still good to
read this.