Product Manual

ManualsBrandsGreenteeth ManualsForestry EquipmentLo Pro Stump Grinder Bolt

If you have any questions or concerns, please call 1-800-473-3683

Installation Instructions

LoPro®

Series

BEFORE YOU BEGIN

Read these instructions completely and

carefully

• Note to installer – Be sure to leave

these instructions for the consumer’s use

• Note to consumer – Keep these

instructions with your Owner’s Manual for

future reference

• Skill level – Installation of these teeth

requires basic mechanical skills. Proper

installation is the responsibility of the

installer. Product failure due to improper

installation is not covered under any

warranty

IMPORTANT - Before you continue,

please check the packing list to make sure it

matches the contents of the boxes.

Disconnect Power

to machine to prevent cutting wheel from

rotating before proceeding. Failure to do so

could result in death or serious injury.

FOR YOUR SAFETY read and

observe all CAUTIONS and

WARNINGS shown throughout

these instructions. While

performing installations described

in this booklet, gloves & safety

glasses or goggles should be worn

at all times.

Summary of content (8 pages)

PAGE 1
Installation Instructions LoPro® Series If you have any questions or concerns, please call 1-800-473-3683 • BEFORE YOU BEGIN IMPORTANT - Before you continue, Read these instructions completely and carefully please check the packing list to make sure it matches the contents of the boxes.
PAGE 2
Installation Preparation TOOLS SUPPLIED: ½” Drive, ½” 6pt Impact Allen Wrench Socket TOOLS YOU WILL NEED: 500 Series Greenteeth® Red/Green 1/2” Socket Wrench 700 Series Greenteeth® Wearsharp® 1/2” Socket Wrench 700 Series Greenteeth® Red/Green 9/16” Socket Wrench 900 Series Greenteeth® Red/Green 5/8” Socket Wrench 700 Series Nut Red/Green 25ft. lbs. (34 Nm) 900 Series Nut Red/Green 35ft. lbs. (47 Nm) ½” Drive Torque Wrench Wire Brush Green-Seize™ TORQUE SETTINGS: 500 Series Nut Red/Green 20ft. lbs.
PAGE 3
Greenteeth® LoPro® Installation Instructions Here are some tips to guide you through the installation process. 1. Locate the pocket set with reverse (over center) pockets on your wheel. If you don’t use reverse (over center) pockets, locate the straight pocket sets. 2. Remove one set of reverse (over center) or straight pockets. 3. Using a wire brush, clean both sides of the wheel where it will come in contact with the pockets.
PAGE 4
11. Before torqueing your tooth down, first make sure that the tooth is seated properly in the pocket. Then tighten the top nut until the tooth is firmly seated and torqued to the appropriate specification for the series; 500 - 20 ft. lbs. (27 Nm), 700 - 25 ft. lbs. (34 Nm), or 900 - 35 ft. lbs. (47 Nm). You may need to hold the tooth in place. Repeat until all teeth are properly torqued. Over-tightening the nut will stretch the threads and degrade the fasteners ability to retain the tooth. 12.
PAGE 5
GREENTEETH® GUARANTEE If you purchase a Greenteeth® setup and are not completely satisfied with its performance, please contact Green Manufacturing at 800.473.3683 to request a return authorization within 30 days of purchase date for a product refund or exchange. WARRANTY: If you are not completely satisfied with your purchase, please contact Green Manufacturing, Inc. at 800.473.3683 to request a return authorization within 30 days of purchase date for a product refund or exchange.
PAGE 6
The Greenteeth® are proudly manufactured in the USA by Green Manufacturing, Inc. Green Manufacturing, Inc. 9650 Packard Rd Morenci, MI 49256 Phone 800.473.3683 • Fax 517.458.1550 ©2016 Green Manufacturing, Inc.
PAGE 7
MATERIAL SAFETY DATA SHEET I - PRODUCT IDENTIFICATION Trade Name: Tungsten Carbide Chemical Family: Refractory Metal Alloy Chemical Formula: WC CAS#: 12070-12-1 II - HAZARDOUS INGREDIENTS Hazardous Components % OSHA/PEL ACGIH/TLV Sec. 302 Sec. 304 Sec.
PAGE 8
Target Organs: May affect the respiratory system. Carcinogenicity: NTP: No IARC: No OSHA: No EMERGENCY AND FIRST AID PROCEDURES: INHALATION: Remove victim to fresh air. Keep warm and quiet, give oxygen if breathing is difficult and seek medical attention. INGESTION: If conscious, give 1-2 glasses of milk or water and induce vomiting (Never induce vomiting or give anything by mouth to an unconscious person). Seek medical attention.