User's Manual

9
5. Remove the battery compartment cover from the back of the remote control, and insert two AA
alkaline batteries (included). The first time you insert batteries, the primary LED light flashes while
the remote control determines the best signal for your lighting system. When this process is
complete, the LED light will remain on for approximately five seconds. When the LED light turns off,
your remote control is ready. Note that this process occurs only during initial battery installation and
does not occur when you replace batteries in the future unless a factory reset is performed.
6. Leave the light fixture switches ON so that power is available when using your remote control to
turn the light bulbs on and off.
Once these steps are complete, you can use the remote control as discussed in the Remote Control Operation
chapter to operate your lighting network.
Installation Tips
Review the safety information. Be sure to review the information contained in the Safety Information chapter
for important safety information you should follow.
Keep radio signals clear. The hardware in your lighting kit has antennas built-in for radio communication. Just
as you might experience reception problems on your mobile phone inside a building, the hardware in your
lighting kit can have trouble communicating if their radio signals are blocked by obstacles such as large metal
panels or walls containing wire mesh. When placing these devices in your home, imagine invisible lines
connecting between them. Try to keep these lines clear from obstruction as much as possible.