Electric Fireplace Mantel Assembly Instructions

GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
For the easiest assembly, use a power Phillips-head screwdriver. DO NOT over tighten the screws.
Step 1
Locate the hearth and place it on the floor. Do not put it up against
the wall at this point in the assembly as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left side panel and the left front panel. Facing the front of
the hearth, take the left side panel, positioning it so the holes in the
blocks on the bottom line up with the screw holes in the hearth.
Locate the left front panel and position it next to the left side panel,
lining up the holes in the blocks with the screw holes in the hearth.
Step 3
Repeat Step 2, but with the right side panel and the right front
panel.
Step 4
Locate the header piece that will be attached to the left
and right legs and will sit above the firebox. Position the
header with the finished side facing the front of the
mantel. Insert and tighten the 4 screws which will hold
the header in place.