Manual

BATTERY CHARGER
18
SPECIFICATION
80V Li-ion Battery charger: 2901402
Input: 120VAC, 50Hz, 5A
Output: 80VDC, 4A
Weight: 3.3 lbs (1.5kg)
Class 2 Battery Charger
CHARGING PROCEDURE
NOTE: T h e battery is not shipped fully charged. It is recommended to fully charge before rst use to ensur e
t hat max imum run time c an b e achieved. This lithium -ion battery will not dev elop a m emory and may be
charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go
into recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of
the battery. Once it is fully charged, the next charge will return to standard charging cycle.
A fully discharged battery pack will require approximately 30 minutes to fully charge from a
discharged state. Plug the charger into an AC power outlet.
• Insert the battery into the charger.
This is a diagnostic charger. The Charger LED Lights will illuminate in specic order to
communicate the current battery status. They are as fo llows:
Charging Fully
Charged
Over
Temperature
Charging
Fault
LED STATUS DESCRIPTION
Blinking Green Charging
Solid Green Fully Charged
Solid Red Over Temperature
Blinking Re harging Fault
d
C
FALSE DEFECT NOTE:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery
from the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is
properly charging. If the status LED is still blinking RED, remove the battery and unplug the
charger for 1 minute. After 1 minute, plug in the charger and reinsert the battery. If the status LED
blinks GREEN, then the battery is properly charging. If the status LED is still blinking RED, the
battery is defective and needs to be replaced.