Manual

BATTERY CHARGER

CHECKING THE CHARGE

If the battery pack does not charge properly:

• Check the current at the power outlet with another tool. Make sure that the outlet is not turned

off.

• Check that the charger contacts have not been shorted by debris or foreign material.

• If the air temperature is above 100ºF or below 45ºF, move the charger and battery pack to a

room temperature location.

• Be sure voltage selector is in correct voltage position before plugging in.

• For use in the U.S.A., the voltage selector switch must be placed in the 120 volt position. For

use in countries other than the U.S.A., the voltage selector may need to be placed in other

than the 120 volt position. Conrm the voltage available at each country location before using

the product.

• This power unit is intended to be correctly orientated in a vertical or oor mount position

WARNING

If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light on

the charger may switch on and illuminate RED. If this occurs allow the battery to cool inside of the

charger for up to 30 minutes. Charging should automatically start once battery has cooled.

CHARGER MOUNTING

1. This charger can be installed hanging on a wall using two #8 screws (not included ).

2. Locate the placement for the charger to be wall mounted.

3. If fastening to wood studs use 2 wood screws (not included ).

4. Drill two holes on center 4.5 in. apart ensuring that they are vertically aligned.

5. If fastening to drywall use wall anchors (not included) and screws to secure the charger to

the wall.

Note: If the battery and the charger won’t be used for a long time, remove the battery from the charger and

pull out the AC power plug.