Quick Start Guide

WARNING
This Quick Start Guide is not a substitute for reading and following the operator’s manual. To reduce the
risk of serious injury, user must read and understand the operator’s manual before using this product.
QUICK START GUIDE
OPERATE THE MACHINE
a.Verify battery charge level. Charge if needed. See battery manual for details.
b.Make sure the seat plug is connected to the machine.
c.Test safety interlock system.
d.Adjust seat to desired position.
e.Raise mower deck to highest position.
f.Keep the steering control levers are in the park brake position. Insert start key and turn to “D“ position, the key
will return back to “C“ position automatically. Wait for 4 seconds until the display shows normally.
Note: The buzzer alarms for one time, the machine is READY TO GO, then you can drive the machine even
without blade working.
g.Lower cutting deck to desired position.
h.Pull right and left steer control levers inward to the NEUTRAL position*.
i.Pull up on PTO switch, press the deck blade speed button to “LOW“ position*.
j.Push steer control levers forward for forward motion and pull for reverse motion.
*Step 8 and step 9 is interchangeable.
WHEN FINISHED
A.Return steer control levers to the NEUTRAL position.
B.Push steer control levers outward into PARK BRAKE position.
C.Push down on PTO switch to turn off the blades.
D.Rotate key in master power ignition switch counterclockwise to the “A“ position.
Note: Turn the key to OFF position, need to wait for 5 seconds or more before restarting the machine.
Missing parts, accessories or need a service center?
Do Not Return to Store
Call : 1-888-909-6757 / 1-855-470-4267
www.greenworkstools.com / www.greenworkscommercial.com
Rev:00
a
b
eg
c
hjAB
d
fD
i
iC
C
A
D
P0803710-01, Rev.B